Aeromotive In-Line Brushless 5.0 Spur Gear Pump With Variable Speed Controller

Brushless In-Line 5.0 Spur Gear Pump with Variable Speed Controller by Aeromotive (P/N 11192)

Experience the unparalleled support for your high-performance engine:

For Gasoline Fuel Injected Engines:

• Up to 3,400 FWHP – naturally aspirated
• Up to 2,600 FWHP – forced air induction

For Gasoline Carbureted Engines:

• Up to 3,600 FWHP – naturally aspirated
• Up to 2,700 FWHP – forced air induction

For E85 Fuel Injected Engines:

• Up to 2,380 FWHP – naturally aspirated
• Up to 1,820 FWHP – forced air induction

For E85 Carbureted Engines:

• Up to 2,520 FWHP – naturally aspirated
• Up to 1,890 FWHP – forced air induction

Note: E85 Compatible, reduce max FWHP by 30%.

Key Features:

• Lighter than the traditional external mount pumps
• Reduced current draw at higher EFI pressures
• Extended service life in methanol and ethanol
• New integral spur-gear pumping mechanism
• 90-PSI continuous operating pressure and up to 150-PSI peak pressure, base plus boost
• This product is not legal for sale or use on emission-controlled vehicles except when used as a direct replacement part matching OEM specifications
• Integral, external brushless controller for clean installation, cooler fuel, and enhanced reliability
• Features ORB-12 inlet and ORB-10 outlet ports
• Requires a straight 12-VDC to 16-VDC power supply
• Not compatible with pulse modulated systems or fuel pump speed controllers

Aeromotive’s True Variable Speed Controller provides the advantages of built-in pump speed control via a dedicated 0-5V analog DC input signal. The Controller capitalizes on Aeromotive's existing brushless technology to reduce fuel flow during low engine demand and decrease an already low current draw, therefore minimizing both motor heat and the introduction of environmental impact via reduced fuel recycling.

Performance Specs:

• EFI Rated flow of 1,700 lbs./hr. @ 40 psi, 13.5 volts
• Carb Rated Flow of 1,850 lbs./hr. @ 9 psi, 13.5 volts