Achieve consistent braking and precise throttle control with this Aluminum Throttle Servo Horn. While steering horns get all the glory, the throttle/brake horn is the unsung hero of a nitro buggy.
Stock plastic throttle horns can flex when you apply the brakes hard. This flex absorbs your servo's power, leading to "mushy" braking or brake fade late in a race as the plastic heats up. This CNC Machined Aluminum Horn is rigid, ensuring that 100% of your servo's torque goes directly into the brake linkage for consistent stopping power every single lap.
Key Features
-
25T Spline: Designed to fit the standard 25-Tooth output shafts of high-performance servos, including:
-
Futaba
-
Savox
-
ProTek RC
-
Reedy
-
Newer Spektrum (Check label; some older are 23T).
-
-
Specific Throttle Geometry: Unlike a generic horn, the hole spacing on this arm is engineered specifically for the TLR 8IGHT-X throttle/brake linkage geometry. This ensures you get the correct ratio of throttle opening to brake application without binding.
-
Clamping Design: Features a side-clamping screw mechanism. This locks the horn onto the servo splines securely, preventing it from working loose under the constant vibration of a nitro engine.
-
7075-T6 Aluminum: Lightweight and incredibly strong.
It will not strip out or flex under maximum braking load.
Compatibility
-
Vehicle:
-
TLR 8IGHT-X (Nitro Buggy)
-
TLR 8IGHT-XT (Nitro Truggy)
-
Note: Not needed for Electric (E) versions as they use ESC braking.
-
-
Servo Type: Standard size servos with 25T Spline.
