Electronic wheel scales are arguably the most critical and expensive setup tools in a racing program. However, a dead control box right before a critical chassis alignment makes the entire system useless. The Longacre 72552 Replacement Charger is the exact OEM power supply needed to bring older-generation, rechargeable Longacre scale systems back to life.
Specifically designed for earlier scale models that utilize internal rechargeable batteries (rather than modern AA alkaline setups), this 110-volt wall charger steps down power to the safe, precise voltage required by the scale's internal processor. Because Longacre used two different plug styles over the years, this specific SKU features the smaller 1/8-inch connector tip. It allows racers to replace a lost, frayed, or crushed power cord without having to send their entire expensive control box back to the factory for retrofitting.
Key Features
-
Direct OEM Replacement: This is a genuine Longacre Racing Products charger, ensuring the correct amperage and voltage delivery to prevent frying the sensitive internal load-cell processors inside the scale box.
-
1/8-Inch Connector Tip: Specifically outfitted with the smaller 1/8" barrel plug to fit exact generations of Longacre control boxes (checking the old charger or the port on the box is highly recommended before purchase to distinguish it from the 1/4" version).
-
Standard 110V Wall Plug: Plugs securely into any standard 110V American wall outlet or trackside generator, delivering a clean, consistent charge to get the system ready between heat races.
-
Pit-Ready Durability: Features a heavy-duty insulated power cord designed to survive being dragged across rough concrete shop floors, exposed to shop fluids, or accidentally stepped on in a crowded race trailer.
