Connect two servos to a single receiver channel with this factory Servo Y-Harness. This harness is standard equipment on many E-flite and ParkZone aircraft, most notably used to connect the Aileron Servos on the T-28 Trojan.
By using this harness, you can control both the left and right ailerons using only the "AILE" port on your receiver, freeing up other channels for gear or flaps.
Key Features
-
Plug and Play: Features standard 3-pin servo connectors that fit Spektrum, JR, Futaba, and Hitec systems.
-
Universal Fit: While listed for the T-28, this is a standard harness that works with almost any electric RC airplane, car, or boat that needs to run two servos from one signal.
-
Flexible Wiring: Uses standard gauge servo wire that is flexible enough to route through foam wings without binding.
-
Secure Connection: Molded connectors ensure a tight fit that won't vibrate loose during flight.
Compatibility
This is the specific replacement part for:
-
E-flite T-28 Trojan (Various sizes, typically the 1.1m / 1.2m series)
-
ParkZone T-28 Trojan (The classic brushed/brushless park flyer)
-
General Use: Compatible with any standard analog or digital servo.
Application Guide
Where does it go?
-
Ailerons: This is most commonly used to connect the two aileron servos (one in each wing) to the AILE port on your receiver.
-
Flaps: Can also be used to connect two flap servos to the AUX1 or FLAP port.
-
Dual Steering: On large scale cars, it connects two steering servos to the STR channel.
