Moving your Solo2 DL from one car to another and need another harness for only power or both power and data input, this is your cable. If you are putting a Solo DL into an older vehicle and need a power supply cable, use this and use only the + and - wires and fold back the can inputs.
The AiM V02569050 harness connects your Solo 2 DL to your ECU via CAN or RS232 wiring. One end has a 7-pin 712 (screw-in) connector to fit the Solo 2 DL, and the other has 6 non-terminated wires (CAN+, CAN-, RS232RX, RS232TX, Power, and Ground).
Does not fit original AiM Solo DL.
AiM Solo2 DL CAN/RS232 Wiring Harness (New Solo 2 DL) Details:
- Manufacturer: AiM
- Manufacturer part number: V02589050
- Fits Solo DL: No
- Fits Solo 2 DL: Yes
- Fits Solo Base Model: No
- Fits Solo 2 Base Model: No
- Pins on AiM Solo DL Side: 7 Pin Thread on connector
- Vehicle Chassis Ends: 6 Non terminated wires
- Vehicle Chassis Ends Break Out: Red=12VDC, Black=Ground, Blue=ECU RS232TX, Blue=ECU RS232 CAN-, Gray ECU RS232 RX, Gray CAN+
AiM Solo 2 DL CAN/RS232 Wiring Harness (New Solo 2 DL) Wiring Codes:
- Red: 9-15VDC
- Black: Ground
- Grey: CAN+
- Blue: CAN-
- Black: ECU RS232 RX
- Blue: ECU RS232TX
Both blue wires are the same color, but each wire has an identifier tag stating the connection type
- Local Pickup Available:
- Yes
- Local Delivery Available:
- Yes
- Additional Handling:
- No
