Stock up on the most easily lost part in RC racing with this 10-pack of 2mm Wheel Nuts. Designed for the entire 1RC Racing 1/18 Scale lineup, these tiny flanged nuts secure your wheels to the axle stubs.
Because these cars race on oval tracks with high vibration and frequent wheel changes for tire tuning, dropping a nut in the carpet is a common occurrence. This pack ensures you have plenty of spares in your pit box so a missing 50-cent part doesn't end your race day.
Key Features
-
Factory Spec: The exact M2 thread pitch (0.4mm) and hex size (4mm) used on 1RC axles.
-
Bulk Pack: Includes 10 Nuts.
Since these are microscopic, 1RC provides enough to replace every nut on two cars, plus spares. -
Flanged Design: Features a wide base (flange) that acts as a built-in washer. This distributes the pressure on the plastic wheel hub, preventing the nut from digging in or cracking the rim when tightened.
-
Standard Hardware: High-quality steel construction.
Specifications
-
Thread Size: 2mm (M2)
-
Pitch: 0.4mm
-
Hex Size: 4mm (Requires a 4mm Nut Driver)
-
Quantity: 10 Pieces
Compatibility
Fits all 1RC Racing 1/18 Scale models:
-
1RC Sprint Car
-
1RC Midget
-
1RC Eastern Dirt Modified (EDM)
-
1RC Late Model
Installation Advice
The "4mm" Tool: You need a specific 4mm Nut Driver to install these.
-
Do Not Use Pliers: Pliers will round off the tiny hex edges instantly.
-
Snug, Not Crushed: These nuts hold plastic wheels onto metal axles. Tighten until the wheel stops wobbling, then give it just a tiny 1/8th turn more. If you crank it down too hard, you will crush the plastic hex inside the wheel, and the wheel will spin freely on the axle (stripped wheel).
-
Check Between Heats: These are metal nuts without nylon inserts (non-nyloc). Vibration can loosen them. Check them before every race!
