Keep your 1/18 scale oval racer running strong with this factory replacement 6.0V NiMH Battery Pack. Designed specifically for the tight confines of the 1RC Racing chassis, this battery provides the correct voltage and weight balance for competitive oval racing.
This is the standard "Stock" battery included with most 1RC RTR kits. It features a 5-Cell configuration (6.0V), which offers more punch and speed than standard 4.8V micro packs, while remaining safe and easy to use with the included wall charger found in the kit.
Key Features
-
Factory Fit: Sized perfectly to slide into the battery tray of all 1RC 1/18 scale vehicles without modification.
-
6.0V Power: Uses 5 NiMH cells in series to deliver 6.0 volts, providing good top speed for small indoor tracks.
-
230mAh Capacity: Offers approximately 10–15 minutes of run time (depending on throttle use), which is plenty for multiple heat races.
-
Micro Connector: Pre-wired with the specific small 2-pin connector that plugs directly into the 1RC receiver/ESC unit.
Compatibility
This battery fits the entire lineup of 1RC Racing 1/18 Scale vehicles:
-
1RC Sprint Car
-
1RC Midget
-
1RC Eastern Dirt Modified (EDM)
-
1RC Late Model
Specifications
-
Voltage: 6.0V
-
Cell Count: 5-Cell NiMH
-
Capacity: 230mAh
-
Connector: 1RC Micro 2-Pin
-
Dimensions: Approx. 33mm x 22mm x 11mm (Check specific tray if using for custom build)
Charging & Care Advice
NiMH Maintenance:
-
Cool Down: Always let the battery cool down to room temperature after a race before charging it again. Charging a hot NiMH battery can damage the cells.
-
Fully Cycle: NiMH batteries benefit from being fully discharged (by driving the car until it slows down) and then fully charged. This helps prevent "Memory Effect" where the battery loses capacity over time.
-
Charger: Use the standard USB or Wall Charger included with your 1RC kit.
